http://www.pent.ca.gov/beh/fa/datacollection_dk.pdf
What are the differences and how do I know when to use which procedure?
Event Recording is a tally or count of behaviors as they occur. Event recording is used when it
is important to know the number of times a behavior occurs. Behaviors measured using event
recording should be ones that occur for short periods of time, such as raising one’s hand, rather
than for extended periods, such as reading or playing. The number of occurrences of a
behavior can be easily and unobtrusively recorded using a hand tally counter, making marks on
masking tape applied to clothing, a desk or wrist, transferring pennies, buttons, or other small
object from one pocket to another. To be useful, we want to know how many times a behavior
occurred within a certain time frame. This becomes frequency.
Frequency recording is a simple counting of how many times a behavior occurs during a
designated period of time. To calculate the frequency of the event, the number of occurrences
of the event within a fixed time interval are counted, and then divided by the length of the time
interval. To use, a target behavior should have a definite, observable beginning and ending and
should not occur at high rates.
Latency Recording is the measurement of the length of elapsed time between the onset of a
stimulus and the occurrence of a behavior.
Latency recording is typically used when we want to
decrease the amount of time it takes for a student to respond to an instruction or other stimulus,
such as time it takes to get started on an assignment following a direction or to give a verbal
response following a question. Latency can be measured using a stopwatch that is started
when the stimulus is provided and stopped when the desired behavior begins.
Denise Keller, PENT Forum 2005 Rev. 12/06
Interval Recording is used to measure the presence or absence of behavior within specific
time intervals. The observation period is divided into equal time periods, such as 5 minute
intervals.
Interval recording is useful for estimating the number of occurrences and/or duration
of behavior and can be used for high frequency behaviors. There are two kinds: Partial-interval
recording and Whole-interval recording.
Partial-Interval Recording: Records whether the behavior was present or absent at any time
during the interval (not concerned with how many times the behavior occurred). A data sheet
divided into the appropriate intervals is used to record occurrences of the behavior. This
procedure tends to produce a slight overestimate of the presence of the target behavior and
should therefore be used when the goal is to produce a behavior reduction.
Whole-Interval Recording: The behavior is only recorded if it is present throughout the entire
interval. This procedure tends to produce a slight underestimate of the presence of the target
behavior and should be used when the goal is to produce an increase in behavior. Both partialinterval
and whole-interval recording requires that someone experienced in taking data is able to
fully attend to the student during the time recording is taking place. A stop watch or other timing
device, such as a digital kitchen timer, is needed along with a pencil and paper divided into the
desired intervals to record on.
Momentary Time Sampling records the presence or absence of behaviors immediately
following specified time intervals. This is sometimes easier for teachers to use as observation
takes place only momentarily at set intervals. For example, every 15 minutes the teacher may
look to see if a student (s) is on task. Momentary time sampling provides an estimate of the
number of occurrences and can also be used to estimate the duration of a behavior.
Duration Recording: When it is important to know how long a behavior occurs, either to target
an increase or decrease in behavior, duration recording can also be used. It is more precise
than momentary time sampling or interval recording. Duration recording records the total time
or percent of time that a behavior occurs within a specified time period. Duration recording can
be used to measure behaviors emitted at high rates. Behavior is measured from the moment of
onset until the moment it stops. A stop watch or other clock that can measure in seconds is
needed.
A-B-C Recording During direct observation, the operationally defined target behavior is
recorded along with the antecedent (stimulus that preceded/ triggered the behavior) and
consequence that followed/was the result of the behavior. Additionally, any behavior that
resulted from consequence can also be recorded. Antecedents, behavior and consequence are
often recorded in narrative form.